We extend our pellet continued support to needed help you achieve the maximum benefit and enjoyment available from your pellet manual stove.
Do this 1/4" at a time.Pellet Sizes The pellet size various according pellet to the nether millstone size.Position stove no closer than 1 " to the wall.Any further inquiries about these items please feel free to contact needed with.It is important to understand and make note of the following items when you first light your stove.This tube must be terminated with a 90 degree elbow pellet or hood.The self igniter will automatically shut off needed after 15 minutes.The stove will need to be manually re-lit. Clinking, silica (or sand) in the manual fuel, along with manual other impurities, can cause clinkering.
The trim control is factory set at the pellet (0) position.
This is due to the "break-in" period of the auger motor.Please see your Owner's Manual or your Operation Maintenance Video for more information about damper adjustments).diams; Automatic lubrication pump, portugues portugues lubricate two roller and main shaft automatically with timming time,make sure pellet machine pellet can work continuously more than 20hours.First, remove the ash pan manual trim piece located below the door.Any adjustments for combustion air should be made at the damper by varying the spacing between the side of the stove and the inside of the damper set collar.Pipe (D) will go through the wall thimble (F).Pull the rod to its fully extended position and measure from the side of the stove to the inside of the collar.Damper Control - The "push/pull" rod located on the lower left-hand side of the stove will NOT need to be manually adjusted every time you turn the fuel feed rate up or down.Combustion Fan Trim - The Combustion Fan Trim is located just above the Heat Output Selector switch.Press the heat output selector switch to position.